Выкрутил из базы два болта одновременно, минус вкручивается обратно, а плюс болтается, не могу поймать резьбу. Нашел описание решения вроде,
Но блин, не могу со своим знанием английского понять алгоритм, может кто сталкивался?
"I put a small phillips-head screwdriver into the 510-connection hole and catched the center hole of that internal cylinder.
Then I turned the base upside down.
Then, watching inside the positive-pin hole, I turned that screwdriver until I saw the hole exactly centered in the positive-pin hole.
Then I screwed the positive screw inside that hole in the internal cylinder, putting attention in keeping that position without moving the cylinder again.
Then I turned the base upside down, centered the internal center cylinder hole with the hole in the 510 connection, using a small screwdriver.
Then I screwed the 510-connection screw AND the spring inside that center hole in the internal cylinder, putting attention in keeping that position without moving the cylinder again.
That technique works perfectly."